Your quote (0 machine)
Home > Agribusiness, Pharmaceuticals and Biotechnologies > Food processing > SNEAP03

Cleaning station in place

This station automatically fills the water with a 30-liter tank of diluted detergent preparation when its low level is detected to its high level. In washing mode, a preparation phase is used to adjust the dose of each detergent, in a closed loop on the preparation tank. When the dose is good for the determined sequence, the automatic valves are actuated to turn on the system to be cleaned. A programmable timer will determine the circulation time of the wash solution in the lines. A sequence will allow the drain of the circuit. Finally, during the rinsing phase, the dosing pumps will not work and the previous sequences will be reviewed again until an acceptable rate of Ph is acceptable; the circuit will be drained automatically.




Technical specifications :

The set is on a stainless steel chassis mounted on wheels and includes :

  • 1 stainless steel tank
  • Two stainless centrifugal pumps
  • 3 electromagnetic dosing pumps made of polypropylene for dosing detergents
  • 3 small HDPE tanks for the storage of detergents (or other packaging of concentrated products
  • 6 kW in-line heater that heats dilute solutions in a closed loop in the tank before injection
  • A Pt100 ohm probe with temperature controller
  • PH meter for online pH measurement, with two thresholds and two relay contacts.
  • The regulation will be of the TOR type.
  • A set of stainless steel pipes and butterfly valves with pneumatic actuators
  • 2 vibrating level level switches for automatic filling of the preparation tanks.
  • 2 detectors to protect the 2 pumps
  • A control and control box including the PLC, the pH meter, the control buttons
  • A Magelis display screen and control of the different sequences
  • A bridging board allowing to manually connect the station on various equipment (inputs, outputs are to be provided for the connection of the station)

This installation is automatic, managed by a TSX 37 PLC, by which the washing sequences and all the washing parameters are programmed:

  • Temperature
  • Concentration
  • Washing time
  • Rinsing time
  • Draining tank N etc ...

It is equipped with the necessary instrumentation for the following functions :

Control and regulation of detergent temperature before washing

  • High level measurement in the tank for filling
  • Low level measurement before centrifugal pumps to prevent it from running dry
  • PH measurement for determination of end of washing
  • Setting the cycle time
DEMANDER UN DEVIS POUR CETTE MACHINE

Other machines associated with the category Food processing
Knife shredder
MP602
Read more
Refiner - stoner
MP606B
Read more
Packing press
MP610
Read more
Hydraulic press 90 liters
MP603B
Read more
Enzyme tank
MP604A
Read more
Plate filter
MP341
Read more
Pasteurization pilot with chambering, tubular exchangers
MP312CR
Read more
Manual packaging, capper
MP607/608
Read more
Vacuum evaporator
MP315
Read more
Autoclave sterilization
MP316
Read more
Semi-automatic crimper
MP317
Read more
Appetizer driver
MP450
Read more
Creamer 125l / h
SCR
Read more
Atomization pilot
MP314
Read more
Fluidized bed drying pilot
MP302CR
Read more
lateral drying and fluidized
MP302S
Read more
Tangential microfiltration pilot
MP353
Read more
Pilot pasteurization plate triquetage (for plant and animal products)
MP313A
Read more
Streaming pasteurization pilot with simplified sorting plates
MP313S
Read more
Maturation tank
MP604C
Read more
Semi-automatic heat sealer
038FEA
Read more
Oven with yogurt 140 pots
038AAA
Read more
Refrigerated cabinet
053HAA
Read more
Fermenter - sterilizer
MP320
Read more
Downflow evaporator
MP1053
Read more
Single-stage pasteurizer
MP312 Mono
Read more