Skip to content. | Skip to navigation

Sections
You are here: Home / Mechanical Engineering / Aerodynamics / Instrumentation / TWO-CHANNELS HOT WIRE ANEMOMETER WITH INTEGRAL VOLTMETER EV240

TWO-CHANNELS HOT WIRE ANEMOMETER WITH INTEGRAL VOLTMETER EV240

The DELTALAB EV240 is a constant-temperature hot wire anemometer which can be operated with one or two measurement channels. It is fully self-contained but can be connected to a computer interface via an acquisition card (EV219).

EV240The measurement channels are independent not only for measuring the wire resistance but also for adjusting the over heat coefficient, the gain and the zero.
The system has a single display unit for the two channels: it is simply switched to the channel to be displayed.
In measurement mode the display indicates the RMS voltages of the selected signals. It has two sensitivity ranges (0-2 V and 0-20 V) and three integration times (1, 5 and 10 seconds).
When two single wire probes or a crossed-wire probe are used, it is essential to connect through an EV219 acquisition system in order to process the data.

 

Technical specifications

- Probes connection: BNC 50 W (2 channels)
- Max. value of probe resistance: 20 W
- Max. current: 250 mA
- Band width: 70 kHz
- Gain : 1, 5, 10, 15,20, 25
- Shift : (0-0.5-1-1.5-2-2.5-3 V) x gain
- Voltmeter:
- integration times: 1, 5 et 10 s
- range:
0 ---> 2 V - 1 mV resolution
0 ---> 20 V - 10 mV resolution
- RMS converter
- Measurement of out-put voltages
d.c. component (channel 1 and 2)
a.c. component (channel 1 and 2)
total component (channel 1 and 2)
- Analogue out-put on Sub D
- Power supply : sector filter include, Fuse AT

ANCILLARY EQUIPMENT :
EV275: Hot wire probe repair kit
EV280: Calibration wind tunnel
EI200: projection micro manometer
EV250: Straight probe (other probes available as standard)
EV295: cable to connect the probe to the EV240

 

Dimension and weight

365 x 235 x 125 mm (L x D x H) - 3 kg

 

Essential requirements

230 V / 40 w / 50 Hz, single phase